![]() ![]() Press and hold the setup button (located inside the device) with the battery in, until the LED stops flashing (approximately 10 seconds). NOTE: The device will not remain awake after resetting and will go into standby mode. If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. Please contact Customer Support for assistance if you're having difficulty with your Ring Alarm.įactory Reset your First Alert Smoke & CO Detector Range Extender (1st generation) and (2nd generation)ĭo not attempt to factory reset your Ring Alarm Base Station without guidance and support from a trained Ring Customer Support expert. If you ever get stuck while troubleshooting your Ring Alarm devices and need to factory reset any of them (as a last resort), you can use the instructions below:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |